At this page you can post questions or start discussions on general topics related to Delft3D Flexible Mesh.

Please select a proper category below (if possible), to post your message or reply to an existing post. Please add tags to your posts to simplify searching.







Average (0Votes)
« Back to 1. Simulation input, run, performance

Model wont run - errors/not orthogonal

Combination View Flat View Tree View
Threads [ Previous | Next ]
Model wont run - errors/not orthogonal
delft3d flexible mesh orthogonality error
Answer (Unmark)
6/28/17 5:27 PM

I'm new to using Delft 3d flexible mesh and am just trying to get a simple model running.
I made a grid for my area ( which when I went to orthogonise came up with a node highlighted in yellow and an error message (pic1).
I couldn't figure out what was wrong and tried fixing it but only thing that allowed me to orthogonise the grid that I could work out was to just delete the offending point, I then added a bed level (.xyz file) and the mesh saved from this grid and bed level ( is shown in pic2. But when i go to run the model it comes up with an error saying not orthogonal (pic3).
What can I do to fix this and get the model to run?




Attachments: (307.1k), (307.0k), pic1.png (219.9k), pic2.png (294.9k), pic3.png (364.4k)
RE: Model wont run - errors/not orthogonal
Answer (Unmark)
6/29/17 1:48 PMas a reply to Anonymous.
Dear Lucy,

As mentioned in the User Manual, orthogonality is very important for accuracy: advised orthogonality values for your grid are around 0.01. The current threshold is 0.5, already quite high.

You could use RGFGRID to improve your grid orthogonality. You need to make the grid orthogonality satisfied before running the model.

Kind regards,

Jing Zhao

RE: Model wont run - errors/not orthogonal
Answer (Unmark)
7/12/17 11:30 AMas a reply to Jing Zhao.
Ok, thanks I'll try to improve the orthogonality