General

At this page you can post questions or start discussions on general topics related to Delft3D Flexible Mesh.

Please select a proper category below (if possible), to post your message or reply to an existing post. Please add tags to your posts to simplify searching.

 

** PLEASE TAG YOUR POST! **

 

 

 

 


Average (0Votes)

Comments

Chil Lee
Hi.

I am a student studying at Korea.

I have simulated using delft3D-FLOW.

Recently, I am trying to simulate a storm surge using Delft3d FM.

I have a simple question.

When I enter the Spider Web grid file on FM, can I use the .spw file using the dashboard?

Does delft3d-FLOW and FM use the same spider web grid file (spw)?

and How do I set the atmospheric pressure in FM?

Average air pressure on bounds/ average initial air pressure are 0 N/m^2 or 101325.00000 N/m^2 ??

Please answer a simple question.

I always thank you, guys.

Thank you.

Posted on 10/20/17 4:44 AM.

Top
« Back to River

Bed level errors

Combination View Flat View Tree View
Threads [ Previous | Next ]
Bed level errors
d flow flexible mesh river bed level
Answer (Unmark)
11/14/17 4:46 PM
I'm new to Delft 3D and i'm using it for my master thesis. I have a bed level file in the format of xyz and I can upload it to the program perfectly, I'm using flexible mesh in Delft 3D. my problem is after i upload my line file and grid, i go to bed level properties to set a specific range for the color scale, the range i'm using is from 0 to 40, however when i go to properties to do so, I find the range values are set from minimum value of -999 to a maximum value of -999, so i tick the box and try to change the values from the ones mentioned earlier to 0 and 40 however they don't change, so i try to upload my file and interpolate, the results are correct but on the color scale the range is still set from -999 to 40, this affects the display of my results, since all i get is one big area covered in the same color. I tried a lot of things but nothing worked.

I even closed the program and tried another grid that i created earlier and this time the values where set from 0 to 0 and i tried to change them and interpolate, I have no idea how to deal with this issue and would appreciate any insight or help given.
I forgot to add that as soon as i upload my file it shows that my entire mesh has a level of -999 which is not possible , also i don't know if that helps, but i'm trying to create a model for a flooding scenario and my levels in the file im trying to upload vary from 20 to 38 meters.