At this page you can post questions or start discussions on general topics related to Delft3D Flexible Mesh.

Please select a proper category below (if possible), to post your message or reply to an existing post. Please add tags to your posts to simplify searching.







Average (0Votes)
« Back to DELWAQ

water quality model

Combination View Flat View Tree View
Threads [ Previous | Next ]
water quality model
Answer (Unmark)
12/15/17 3:13 AM

I have completed current modelling in D-Flexible Mesh and am doing water quality modelling now. Purpose is to understand concentration change in an area inside the domain. I have imported the .hyd file from D-Flexible Mesh to D-Water Quality and created fractions and boundary data. I see that as default model specifies 1 to the domain and 0 to boundary condition (where I forced tidal level data). What I need, is to give fraction 1 to the area of interest and 0 to the domain and then observe the concentration change within the area. Appreciate if someone help on this.