coupled flow-wave model stalls during initialisationcoupled flow-wave model stalls during initialisationhttps://oss.deltares.nl/c/message_boards/find_thread?p_l_id=1806675&threadId=4204182024-03-28T13:48:13Z2024-03-28T13:48:13ZRE: coupled flow-wave model stalls during initialisationAdri Mouritshttps://oss.deltares.nl/c/message_boards/find_message?p_l_id=1806675&messageId=4207312014-05-02T12:48:26Z2014-05-02T12:48:26ZHi Andy,<br /><br />Double check that online visualisation is switched off, see <a href="">this FAQ</a>.<br /><br />Double check that file dioconfig.ini is present in the working directory.<br /><br />Be sure to start a calculation with a working directory as clean as possible, see <a href="">this FAQ</a>.<br /><br />Do you see both FLOW and WAVE being started? Your description points to WAVE not being started (correctly). Does the WAVE screen output contain error messages? Does the tri-diag file contain error messages?<br /><br />Can you still run the "...\examples\03_flow-wave" testcase in the source code in the same way as you try to start your calculation?<br /><br />Regards,<br /><br />AdriAdri Mourits2014-05-02T12:48:26Zcoupled flow-wave model stalls during initialisationAndy ONeillhttps://oss.deltares.nl/c/message_boards/find_message?p_l_id=1806675&messageId=4204172014-05-01T16:22:31Z2014-05-01T15:51:50ZHi,<br /><br />I'm trying to troubleshoot what's causing my model to stall. It's a hires FLOW-WAVE simulation, and I've run it before with different initial conditions, but upon setting this one up and trying to run it, it stalls during the initialisation process:<br />Part VII - Initialisation output... <br /><br />It writes the FLOW2WAVE_DATA file, and then stops doing anything. No errors are given. I've gone through all the input data and can't find anything. Any primary suspects I should be looking at? <br />I greatly appreciate any suggestions, as this is time-sensitive. <br /><br />Many thanks.Andy ONeill2014-05-01T15:51:50Z