intro story Coast / Estuary

Coast / Estuary

Coastal systems are among the most dynamic physical systems on earth and are subject to a large variety of forces. The morphodynamic changes occurring to coastlines worldwide are of great interest and importance. These changes occur as a result of the erosion of sediments, its subsequent transport as bed load or suspended load, and eventual deposition. 
 
Estuaries are partly enclosed water bodies that have an open connection to the coast. Estuaries generally have one or more branching channels, intertidal mudflats and/or salt marshes. Intertidal areas are of high ecological importance and trap sediments (sands, silts, clays and organic matter).
Within the Delft3D modelling package a large variation of coastal and estuarine physical and chemical processes can be simulated. These include waves, tidal propagation, wind- or wave-induced water level setup, flow induced by salinity or temperature gradients, sand and mud transport, water quality and changing bathymetry (morphology). Delft3D can also be used operationally e.g. storm, surge and algal bloom forecasting. 
 
On this discussion page you can post questions, research discussions or just share your experience about modelling coastal and/or estuarine systems with Delft3D FM. 
 

** PLEASE TAG YOUR POST! **

 

 

Sub groups
D-Flow Flexible Mesh
DELWAQ
Cohesive sediments & muddy systems

 

 

Message Boards

FLOW-WAVE coupling problem

HR
Hafizur Rahman, modified 2 Years ago.

FLOW-WAVE coupling problem

Youngling Posts: 5 Join Date: 4/4/17 Recent Posts


I am trying to set up a trial model for my project using FLOW-WAVE coupling.i had followed the steps provided in the WAVE manuals.While running the simulation some meassage appeared and the simulation seems to hang at initial state for about 3 hours.. i have attached two pictures of the message and the place where simulation hanged.

here are some lines from flow dianosis file

*** WARNING Latitude of your model is 0 degrees, model located at equator
*** WARNING MAP stop time outside simulation period; will be reset
*** WARNING HIS stop time outside simulation period; will be reset
*** WARNING Comm. stop time outside period for writing file; will be reset
Creating new trih-stMartin-1.dat
Creating new trih-stMartin-1.def
Creating new trim-stMartin-1.dat
Creating new trim-stMartin-1.def
*** MESSAGE Nodal factors updated at 2016-03-02 **:**:**.0000
*** ERROR
NEFIS message 6004:
Group 'WAVNT ' does not exist in data file
Adri Mourits, modified 2 Years ago.

RE: FLOW-WAVE coupling problem (Answer)

Yoda Posts: 1224 Join Date: 1/3/11 Recent Posts
Hi Hafizur,

Please have a look at the FAQ.

Regards,

Adri